How Much Does It Cost to Withdraw USDT on Binance? TRC-20 vs ERC-20 Explained
A full breakdown of Binance's on-chain USDT withdrawal fees. From the differences between TRC-20, ERC-20, and BEP-20 to which network to pick, here's how to withdraw for the least money.
Short answer first: Binance's on-chain USDT withdrawal fee depends on the network — roughly 1 USDT per transaction on TRC-20, 5-30 USDT on ERC-20 (adjusted dynamically with Ethereum network congestion), about 0.3 USDT on BEP-20, and about 1 USDT on Solana. For everyday small withdrawals, TRC-20 or BEP-20 is the most cost-effective. Before withdrawing, check the Binance Official Site for real-time rates; the Official Binance App gives you a clearer withdrawal screen on mobile, and iPhone users who can't install it should see the iOS installation guide.
USDT is a stablecoin, but it runs on multiple public blockchains. Transfer speed, fees, and ecosystem support vary completely between chains. Below is a clear comparison of the main USDT networks Binance supports.
1. Binance USDT Withdrawal Fee Comparison Table
| Chain | Network code | Withdrawal fee | Arrival time | Minimum withdrawal |
|---|---|---|---|---|
| TRON | TRC-20 | 1 USDT | 1-3 minutes | 10 USDT |
| Ethereum | ERC-20 | 5-30 USDT | 3-15 minutes | 10 USDT |
| BNB Smart Chain | BEP-20 | 0.29 USDT | 1-3 minutes | 10 USDT |
| Solana | SOL | 1 USDT | Instant | 10 USDT |
| Polygon | MATIC | 0.8 USDT | 1-3 minutes | 10 USDT |
| Arbitrum | ARBI | 0.5 USDT | 1-3 minutes | 10 USDT |
| Optimism | OP | 0.5 USDT | 1-3 minutes | 10 USDT |
| Avalanche C-Chain | AVAXC | 0.8 USDT | 1-3 minutes | 10 USDT |
Figures are for reference — Binance adjusts actual rates dynamically. The withdrawal page always shows the current fee.
2. The 3 Most Commonly Used Chains
TRC-20 (TRON)
The most widely used network for USDT transfers.
| Metric | Value |
|---|---|
| Fee | 1 USDT |
| Speed | 1-3 minutes |
| Chain ecosystem | Moderate, mainly used for transfers |
| Merchant acceptance | Extremely high |
| Best for | Small to medium transfers, C2C merchant payments |
Pros:
- Low, fixed fees
- Fast
- Supported by most exchanges and wallets
Cons:
- Fewer on-chain DApps (not ideal for DeFi)
- TRON carries higher regulatory scrutiny than some other chains
ERC-20 (Ethereum)
The original USDT network.
| Metric | Value |
|---|---|
| Fee | 5-30 USDT (dynamic) |
| Speed | 3-15 minutes |
| Chain ecosystem | The most mature |
| Merchant acceptance | High |
| Best for | Large transfers, DeFi |
Pros:
- The most mature ecosystem (Uniswap, Aave, and more all live on Ethereum)
- The strongest security track record (the longest history)
- The most DApps
Cons:
- High fees (not cost-effective for small amounts)
- Fees spike during network congestion
- Relatively slow
BEP-20 (BNB Smart Chain)
Binance's own chain, with the lowest fees.
| Metric | Value |
|---|---|
| Fee | 0.29 USDT |
| Speed | 1-3 minutes |
| Chain ecosystem | Fairly mature (BSC DeFi) |
| Merchant acceptance | Moderate (less universal than TRC-20) |
| Best for | Withdrawing within Binance to your own wallet for DeFi |
Pros:
- Lowest fees
- Fast
- Convenient for moving funds within the Binance ecosystem
Cons:
- Not supported by some exchanges
- Some merchants won't accept it
3. Which Chain to Pick by Withdrawal Amount
Small amounts (< 1,000 USDT)
Prioritize TRC-20 or BEP-20:
- TRC-20: 1 USDT fee, you receive 999 out of 1,000 USDT
- BEP-20: 0.29 USDT fee, you receive 999.71 out of 1,000 USDT
- ERC-20: 5-30 USDT fee, you receive 970-995 out of 1,000 USDT (not worth it)
Medium amounts (1,000-10,000 USDT)
Still favor TRC-20:
- TRC-20: 1 USDT is 0.01-0.1% of the total
- ERC-20: 5-30 USDT is 0.05-3% of the total
Large amounts (> 10,000 USDT)
Consider ERC-20 (pricier but well-tested) or TRC-20:
- ERC-20: 30 USDT is under 0.3% of the total (the percentage shrinks at larger amounts)
- TRC-20: still just 1 USDT — still the best value
In practice, even at large amounts, TRC-20 remains the most cost-effective choice, unless you're sending to a wallet or contract that only supports ERC-20.
4. The Full Withdrawal Process
Step 1: Go to the withdrawal page
On desktop: "Wallet" → "Spot Wallet" → click "Withdraw" on the USDT row. On the app: "Wallet" → "Spot" → select USDT → "Withdraw".
Step 2: Select the network
Pick your chain from the dropdown. Binance shows the current fee for each network.
Important: picking the wrong network means losing your coins. If your destination address only supports TRC-20, do not select ERC-20 — the funds will be lost (customer support recovery is possible but has a low success rate and comes with a fee).
Step 3: Fill in the withdrawal details
| Field | Note |
|---|---|
| Withdrawal address | The destination wallet address — copy and paste, don't type it manually |
| Amount | How much USDT you're withdrawing |
| Memo | Some platforms require a Tag/Memo (USDT does not) |
Step 4: Double-check the address
Compare the destination address you entered against the one you meant to send to, checking the first 4 and last 4 characters match. This guards against "clipboard hijacking" malware that silently swaps addresses.
Step 5: 2FA verification
Enter your 2FA code (Google Authenticator, etc.). The first withdrawal to a new address also requires both email and SMS verification.
Step 6: Submit and wait
After confirming, your withdrawal enters the queue:
| Stage | Duration |
|---|---|
| Binance risk review | 1-30 minutes |
| On-chain broadcast | Instant |
| On-chain confirmation | Varies by chain (see table above) |
| Arrival at destination wallet | Sum of the above |
5. A Few Withdrawal Details Worth Knowing
Withdrawal address whitelist
Go to "Account" → "Security" → "Withdrawal Address Whitelist" to enable it. Once on:
- Only pre-approved addresses can receive withdrawals
- Adding a new whitelisted address requires email + 2FA + a 24-hour cooldown
- This significantly reduces theft risk
Common reasons withdrawals fail
| Reason | Fix |
|---|---|
| Network congestion | Wait for on-chain confirmation |
| Risk review | Wait for Binance to process (usually under 30 minutes) |
| Incorrect address format | Resubmit the withdrawal |
| Insufficient balance including fee | Reduce the withdrawal amount |
| Large-amount limit | Split into multiple withdrawals |
Withdrawal speed comparison
| Chain | Average speed |
|---|---|
| Solana | 30 seconds |
| BEP-20 | 1 minute |
| TRC-20 | 1-3 minutes |
| Polygon | 1-3 minutes |
| Arbitrum / Optimism | 1-5 minutes |
| ERC-20 | 3-15 minutes |
6. Four Principles for Choosing a Chain
Principle 1: Check what the destination supports
The most important factor: what chains does your destination address support?
- Sending to OKX or Huobi: all major chains are supported
- Sending to a non-custodial wallet (MetaMask): usually ERC-20, BEP-20, Polygon, or Arbitrum by default
- Sending to TronLink: TRC-20
Principle 2: Fee as a percentage of amount
For small amounts, pick the lowest-fee chain; for large amounts, an established chain is fine.
Principle 3: Speed requirements
Need funds instantly (arbitrage, trading): choose SOL or BEP-20. No rush (personal storage): TRC-20 is sufficient.
Principle 4: Security considerations
ERC-20 is the most secure (longest history, strongest consensus). But for large withdrawals, private key custody matters more than the chain itself.
7. Withdrawal Fee Calculation Examples
Assume you're withdrawing 1,000 USDT to a wallet that supports all chains:
| Chain chosen | Fee | Amount received | Loss percentage |
|---|---|---|---|
| TRC-20 | 1 USDT | 999 | 0.1% |
| BEP-20 | 0.29 USDT | 999.71 | 0.029% |
| ERC-20 (congested) | 30 USDT | 970 | 3% |
| ERC-20 (quiet) | 5 USDT | 995 | 0.5% |
| Solana | 1 USDT | 999 | 0.1% |
| Polygon | 0.8 USDT | 999.2 | 0.08% |
BEP-20 is the cheapest by fee alone, but TRC-20 has the best overall compatibility, making it the most practical choice overall.
8. Frequently Asked Questions
Q: What if I pick the wrong network for a withdrawal? A: If the destination address happens to support the network you picked, no harm done. If it doesn't, the funds are lost. You can contact Binance support for a recovery attempt, but the success rate is low and typically requires a 50-1,000 USDT recovery fee.
Q: What if I enter the wrong withdrawal address? A: On-chain transactions are irreversible. Funds sent to a wrong address are lost and cannot be recovered. Always double-check the address before withdrawing.
Q: Is USDT the same coin across different chains? A: It's the same stablecoin, but it's a different contract on each chain. 1 TRC-20 USDT equals 1 ERC-20 USDT in value, but the contracts differ, so transfers must use the matching chain.
Q: Do I need to complete KYC to withdraw? A: Yes. Unverified accounts cannot withdraw.
Q: Is there a minimum withdrawal amount? A: The minimum for USDT on any chain is 10 USDT. You can't withdraw below that amount.
Q: Can I make multiple withdrawals to reach a large total? A: Yes. Binance's daily limit is 8 million USDT, and you can split it across multiple withdrawals. Just keep in mind each one incurs its own fee.
For most situations, TRC-20 is the best choice for withdrawing USDT from Binance — a 1 USDT fee and 1-3 minute arrival time. Only use ERC-20 when you specifically need Ethereum DeFi access or your destination address only supports ERC-20. The Deposit Withdraw category on this site has more detailed guides on on-chain transfers.